ODB++ Solutions Alliance Community forum ODB++ Forum ISSUE: ODB++ Inside Utility and Cadence 17.2

This topic contains 1 reply, has 2 voices, and was last updated by  Patrick McGoff 3 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #6094


    Reporting an issue with this utility removing non functional pads from pins that are functional. We discovered the issue while running through valor checks which identified two traces as stubs because the pads are missing from the connector pins. Highly recommend that you do not select the option to remove non functional pads with this utility until it is resolved. Recommend adding a note to your fabrication drawing and instruct the board house to remove non functional pads.


    Patrick McGoff

    Hi Cole,

    Thanks for posting the issue you are experiencing with non-functional pad removal. I will follow-up with you via email to help with the resolution.

    In the future, please use the support “click here” link on this page if you are in need of technical assistance.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.