ODB++ Solutions Alliance Community forum ODB++ Forum ODB++ exporter adding silkscreen layer into bottom copper

Tagged: 

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #6131
    David Morse
    Member

    The exporter is putting the bottom assembly layer in the bottom etch layer. Not overwriting it, but combining it, so that all the etch is shorted by any component line or assembly designator.
    Interestingly, the entire ASSY-2 layer is blank, even though the fabrication notes and drawing border should have been apparent.
    ASSY-1 and the top layer are fine. It’s only the bottom layer and ASSY-2 that is combining.

    Gerbers export without error.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.